When we set out to build a subwoofer box for the new 2017 Ford F250 Crew Cab the first thing that changed from our 2008-2016 F250 subwoofer box was how the seats attached to the floor. You will notice 2 small notches cut into the bottom of the box. These are designed to fit around seat attachment brackets on the floor. These notches cause any cutout in the middle of the box to have to shift up therefore reducing the mounting depth to around 4.25″ compared to 5.25″ of mounting depth available on each end of the box.
The top of the subwoofer box has a notch cut in to fit around the power sliding window motor. The passenger’s side of the box is also lower then the driver’s side due to hardware on the passenger’s side.
The box can hold a variety of subwoofer combinations including 2-8’s, 2-10’s ,2-12’s or 1-13″ or built to hold one subwoofer and use the other side of the box to have an amp rack. Due to the lower Passenger’s side of the box 2-13″ subwoofers will not fit.
The 2017 F250 Crew Cab subwoofer box will restrict ever so slightly the folding up of the rear seats when installed. If so desired the holes where the seat bolts attach into, can be widen by a 1/4″ allowing the bolts to slide forward and thus the seat will move forward just enough to allow the folding up of the rear seats.
As always all of our subwoofer boxes are built in the USA and built as the orders come in. No pulling a 6 month old box off the shelf, built overseas collecting dust and mildew. Fresh wood delivered weekly. We welcome any ideas you may have to improve our products. Thank you